Purveyor-ready reports on every job.
Home › Chlorination › Tank Disinfection
California Backflow & Chlorination disinfects potable water storage tanks to AWWA C652 standard for new tank commissioning and for tanks returning to service after repair, cleaning, or a suspected contamination event. Our crews are DPR-licensed and coordinate directly with your water purveyor.
PHOTO — technician disinfecting a potable water storage tank
New storage tanks must be disinfected before they are placed into service. Existing tanks require disinfection after interior repairs, recoating, structural work, cleaning that breaches the tank interior, or any event that may have introduced contamination, such as an open hatch, flood exposure, or a failed vent screen.
Purveyors and inspectors generally require documented disinfection and a passing bacteriological result before releasing a tank for potable use.
PHOTO — potable water storage tank exterior with access hatch
The tank is isolated from the active distribution system before any chlorine is introduced, protecting the rest of the network.
Chlorine solution is applied at the concentration and contact time AWWA C652 specifies for the method appropriate to your tank.
Residual chlorine is neutralized before discharge so disposal meets local and state requirements.
The tank is flushed and refilled with potable water once disinfection is complete.
Samples are collected and processed through our state-certified laboratory partner to confirm the tank is safe for use.
Chlorine residuals, contact time, dechlorination, and lab results are compiled into a report ready for direct submission, same-day when lab results allow.
Every job is performed under C-36 Contractor License #1117687 and DPR License #140023, backed by the credentials California requires.
Bacteriological and water-quality samples are processed through our state-certified laboratory partner, giving purveyors results they accept without question.
Every report is formatted for direct submission to your water purveyor or inspecting agency, with same-day turnaround whenever lab results allow.
Plumbing, chlorination, and backflow work are handled by the same crew in one visit, so you are not coordinating three separate contractors.
We confirm the method required for your tank and isolate it from the active distribution system.
Chlorine solution is applied to AWWA C652 concentration and held for the specified contact time.
Residual chlorine is neutralized, then the tank is flushed and refilled with potable water.
Bacteriological samples go to our state-certified lab, and a purveyor-ready report follows same-day when results allow.
Isolation, chlorination, and hold time typically run one to two days depending on tank size and method, with lab turnaround added after sampling. We coordinate the schedule so the tank returns to service as quickly as the purveyor’s requirements allow.
New tank commissioning, interior repairs or recoating, any event that opens the tank to potential contamination, and any purveyor or inspector requirement following maintenance work.
Yes, from small hydropneumatic and booster tanks to large ground-level and elevated storage tanks. Call (858) 523-8113 with your tank’s capacity and access details for a scoped quote.
We return promptly to redisinfect and resample, and we keep the purveyor informed of the revised schedule so the project timeline is affected as little as possible.
✔ Same-Day Scheduling ✔ Upfront Pricing ✔ Purveyor-Ready Reports ✔ Licensed & Insured
Licensed C-36 Contractor #1117687
DPR License #140023
ABPA-Certified Backflow Testers
State-Certified Laboratory Partner
(858) 523-8113
spencer@cal-backflow.com
Serving Los Angeles, Orange, San Diego,
San Bernardino & Riverside Counties